Reasons and methods for overloading of extruder in cable extruder machine equipment:

1. The mud is too dry: At this time, you should take out the mud that is too dry. It is best to remove the mouth and head of the cable extruder machine, and start the machine to drain the dry material in the mud tank before installing and running. Appropriately increase the molding moisture within the range.

2. The cable extruder machine will shut down for a long time, and the remaining material in the mud tank will become dry and hard. This will not only cause serious overload, but sometimes fail to start. In order to prevent this from happening, do not turn off the water at the machine port when the machine is shut down for more than 8 hours. For the two-stage vacuum extruder, the mud in the upper mud tank should be properly supplied with water to keep it moist. If the machine is shut down at 2 If it is more than days old, try to empty the mud and then stop the machine.

Matters needing attention: When overloading, the load of the motor will remain high and the clutch will slip. At this time, do not force it to start, so as not to damage the relevant parts, or even cause major accidents such as squeezing the mud cylinder and the nose.